Process & Control Engineering
PLCs, SCADA and control loops that keep a plant steady.
Processes that stay *under control*
Automation from the field instrument to the operator screen, programmed to behave on the worst day.
I design and program the control side of a process: instrumentation, PLC logic, SCADA and HMI, and the control loops that hold a plant at its setpoints.
The goal is a system operators trust: clear alarms, predictable behaviour and documentation that survives the next shift change.
Skills & tools
What a Process & Control Engineering project draws on
PLC Programming
Logic that fails safe.
SCADA & HMI
Screens operators trust.
Instrumentation
Field measurement and calibration.
Control Systems
Modelling and tuning.
How I
work
A look at how a typical Process & Control Engineering project comes together
01
Process Understanding
We walk the process, its instruments and its failure modes, and write the control philosophy before any logic is programmed.
Outcomes
- Control narrative
- I/O list
- Alarm philosophy
02
Programming & Simulation
PLC logic, HMI screens and loop tuning are built and tested against a simulation, so commissioning is a confirmation, not a discovery.
Outcomes
- PLC program
- HMI and SCADA screens
- Tuning report
03
Commissioning
Site acceptance, loop checks and operator training, then documentation that stays useful.
Outcomes
- SAT results
- Operator training
- Maintenance manual
Related Work
Siemens TIA Portal, Omron CX-Programmer and Schneider Machine Expert so far, and I am comfortable picking up others from the documentation.
Yes. I audit what is there, plan a staged migration and keep the plant running throughout.
Yes. Modelling, PID tuning and verification are part of the work, not an afterthought.
Common Questions
Answers to what people ask most about Process & Control Engineering
Need help with your project?
Let’s work together!